WPL C14 C24 3D Printed Files by Alexander Zaikin
Hello, Edward and all WPL RC team!
I'd like to contribute .stl file for your site STL Download section.
1. WPL C14|C24 Panhard rod & winch under the hood
Description
===
The aim of a Panhard Rod is to reduce lateral shift of the axle. And in case of WPL transmitter, which doesn't have end points correction, it reduces incline of the model when wheels are turning on a big angle.
This also prevents the model from toy-like jumping to some extent on off-road driving.
To fasten a Panhard Rod you will need two details — pull rod base seat with a place for fasten and bracing to the base. Base in this case is electronic equipment tray.
If you will use this equipment tray, there will be two bonuses — the place for a winch under the hood and shifted to opposite side servo, besides the niches for the wires and the space for a large external ESC.
It's good for servo to be shifted because the further servo from the axle fasten place the less undesired wheel turn during the shocks work. (the cosine of the small angle and so on).
I think it doesn't need to clarify why do you need a winch?
The equipment tray and servo lock **must be printed as one assembly**. I separated them so you easily could make servo lock for different servo (in that case I use 1181MG servo). I made the square on the equipment tray floor for you to easy pairing them.
There is no need to fix the servo with screws. We used our car surely more then 100 accumulators, it suffered drops and pushes from many children, but it is still on it's place.
For the winch I use the motor with gear unit. It could be pluged in to the stock connector for external devices on a WPL v3 receiver. It's strong enough to lift the car on a winch. The coil for the winch is also in the materials.
Print settings
===
Rafts:No
Supports:Yes
Resolution: 200
Infill: 100
2. WPL C14|C24 one speed transfer box with flat bottom
Description
===
WPL C14 C24 single-speed transfer box with a flat bottom.
I made it to replace single-speed gearbox frame that stick out of the car bottom.
It's better to print the middle part out of ABS, because the engine and reducer will heat up significantly.
Print settings
===
Rafts: Doesn't Matter
Supports: No
Resolution: 200
Infill: 50
3. WPL C14|C24 rotating mirror
Description
===
WPL C14/С24 rotating mirror.
Children tore the mirrors from model off too fast)
I noticed that the children were tearing off the mirrors, trying to turn them.
So, here are the rotating mirrors.
Print settings
===
Rafts: Yes
Supports: Yes
Resolution: 100
Infill: 100
4. WPL C24 side rack
Description
===
Side rack on WPL C24 instead of the canopy cabin.
Print settings
===
Rafts: No
Supports: Yes
Resolution: 200
Infill: 100
Best regards,
Alexander Zaikin
Alexander Zaikin